In industrial applications such as coal-fired (oil, gas) boilers, petrochemicals, metallurgy, aerospace, etc., when igniting, a special tool, a high-energy igniter, is needed. Although the high-energy igniter has a certain service life, if the method is used properly, the service life of the high-energy igniter can be appropriately extended.
Secondly, the shorter the ignition time with a high-energy igniter, the better, and it should be kept within 30 seconds. If the ignition time exceeds 30 seconds, it needs to rest for 1 minute before reuse. When it is ignited, the combustion air should be turned off for safety. When the ignition is successful, the combustion air should be turned on to increase the fire.
Again, the atomization effect of the fuel is good, which can greatly improve the success rate of ignition and reduce the frequency of use and ignition time of the high-energy igniter. Operators should learn more about the use of high-energy igniters, use high-energy igniters in accordance with the correct operating procedures, and combine these three tips to effectively extend the life of high-energy igniters.
High-energy igniters are widely used in coal-fired (oil, gas) boilers, petrochemicals, metallurgy, aerospace and other industries. They are used for starting ignition of boilers, coking furnaces, furnaces, etc., igniting medium: gas, light oil, Heavy oil and so on. It can be seen from the application of high-energy igniter that high-energy igniters are mostly used in flammable and explosive places, so it is especially important to operate high-energy igniters safely and safely.
How to use the high-energy igniter correctly and safely? Jeneng Power Xiaobian summed up the following points for you:
1. Before use, check whether the high-energy igniter device is connected correctly and the contact is reliable. The horn of the igniter protrudes into the fuel zone by 100~200mm. When the high-energy igniter is not connected to the ignition cable or the igniter, do not energize.
2. When using a high-energy igniter, first turn on the ignition switch to make it in the ON state, and then turn on the corresponding fuel part. Whether it is spray or jet, you should pay attention to this when using it.
3. During the ignition process of the high-energy igniter, the user should pay attention to the initial stage of ignition. The combustion air should be turned off or as small as possible. When the ignition is successful, the combustion air will be increased according to the demand. When the fire is too large, it should be Turn off the combustion air in time.
4, the working cycle of high-energy igniter should be strictly observed. Generally, the ignition time should not exceed 30 seconds. At the same time, after one use, the high-energy igniter needs to be cooled accordingly, and it can be opened again after more than one minute.
5. Maintenance of the high-energy igniter must be performed after the power is turned off for 5 minutes (ensure that the remaining charge of the capacitor is discharged through the bleeder resistor). High-energy igniters must shut off system power during long-term shutdowns;
