The RTO incinerator, or regenerative waste gas treatment equipment, is a waste gas treatment equipment for the treatment of medium and low concentrations of volatile organic waste gas. Its basic principle is to oxidize the organic components in the waste gas at high temperature to produce CO2 and H2O, thus removing them.TO is a direct-fired waste gas treatment equipment. It is a waste gas treatment equipment that uses the heat generated by the combustion of auxiliary fuel to raise the temperature of combustible harmful gas to the reaction temperature so as to produce oxidation decomposition.Today,Generalflame will introduce the difference between RTO incinerator and To incinerator in detail.
First, let's take a look at how RTO waste gas treatment equipment works. RTO is to heat organic waste gas to more than 760 degrees Celsius, which causes the VOC in the waste gas to oxidize into carbon dioxide and water.The high temperature gas generated by oxidation flows through the special ceramic heat storage body, which heats up the ceramic body and "accumulates heat". This "accumulates heat" is used to preheat the subsequent organic waste gas, so as to save fuel consumption of waste gas warming up.Ceramic heat accumulator shall be divided into two or more zones or rooms, each of which shall go through the procedures of heat storage, heat release and cleaning in turn, and work continuously.After the regenerator "exothermic", some qualified clean exhaust gas should be introduced to clean the regenerator (to ensure the VOC removal rate above 95%). Only after the regenerator is cleaned can it enter the "regenerator" procedure.RTO regenerative waste gas treatment equipment, its characteristics are: operating cost, organic waste gas treatment efficiency is high, in the domestic and foreign widely used in painting process of drying waste gas treatment, as well as other industries such as chemical electronics similar waste gas treatment.Applicable waste gas: medium and low concentration 100~3500mg/m3, decomposition efficiency: 95%--99%.
RTO incinerator waste gas treatment equipment is suitable for oil refineries, rubber factory, tanneries, printing plant, chemical plant, pharmaceutical factory, metal foundry of Chinese and western, plastic recycling plant, spraying solvent, food processing plants, meat processing plant, slaughterhouses, poultry feed, paper, sewage treatment plant, waste gas purification treatment of refuse transfer station, etc.
TO incinerator process, the role of organic mixed waste gas by induced draft fan directly into the waste incinerator, organic mixed waste gas into the heat exchanger for preheating first, and then into the furnace, under the action of high temperature in the flames of burning machine (680-760 ℃), the mixed gas into carbon dioxide and water, is due to combustion heat release process, so after combustion of gas temperature is higher (generally at about 760 ℃), make it into the heat exchanger (organic waste) with the low temperature gas for heat exchange, made into a mixture of exhaust gas temperature increase or reaction temperature is reached, if short of reaction temperature,The heating system can realize the compensation heating through the automatic control system, so that it burns completely, which not only saves energy, but also can effectively remove the mixed waste gas.
TO incinerator waste gas treatment equipment is suitable for spraying solvent, food processing plant, meat processing plant, slaughterhouse, poultry feed farm, paper mill, sewage treatment plant, garbage transfer station and other industries of a kind of waste gas treatment equipment.
